A UV1 fault (fault 2 on the touchscreen) is a supply undervoltage fault. The VFD detected that the input voltage is too low for the drive specifications. There are three possible causes for this:
1. The supply voltage is too low for the drive rating, for example if 120V is being provided to a 240V drive.
2. There was a momentary power loss. If the proper power has been restored, this fault code can be reset to resume fan operation. If a fan is being run on a generator, this is not recommended and can cause many issues.
3. There is a loose or missing wire on the input of the VFD. Verify that all wires are properly connected to the disconnect switch, the fuse block, and the proper input terminals on the VFD. Ensure the disconnect switch is assembled properly.
Comments
0 comments
Please sign in to leave a comment.